Holley EFI Ultra Lo-Ram EFI Manifold Kit GM LS1/LS2/LS6 300-623
Specifications:
| Description_INV | KIT, INT. MANIFOLD, LS1 LO-RAM, SATIN |
| Description_DES | Ultra Lo-Ram EFI Manifold Kit GM LS1/LS2/LS6 |
| Description_EXT | Burst Panel Flange |
| Description_MKT | The Holley LS1/2/6 Ultra Lo-Ram intake manifold kits are designed for GM LS Gen III and IV engines equipped with GM LS1/2/6 (cathedral port) cylinder heads. These intake manifolds will work with OE or aftermarket cylinder heads. Plenum top is machined for a standard "large" 6-1/8" x 3-1/8" burst panel. SFI approved burst panels, burst panel frame sets, and gaskets may be purchased from various manufacturers such as Allstar Performance or Specialty FastenersThe Ultra Lo-Ram intake manifolds are designed for forced induction (supercharged or turbocharged) engine applications and the 105 mm throttle body part number 112-581 or similar models. The base intake manifold is designed with a lower overall height to fit under a stock or mildly modified hood. The 300-623 Ultra Lo-Ram plenum entry was configured to provide a very low profile modular intake manifold suitable for turbocharged or centrifugally supercharged engines. The fuel rail kits come with two sets of brackets. A set for long (usually standard length) fuel injectors and a set for short (such as Pico, or LS7) fuel injectors. |
| Description_FAB | Designed for GM LS Gen III and IV engines equipped with GM LS1/2/6 (cathedral port) cylinder heads |
| Description_FAB | Designed for forced induction (supercharged or turbocharged) engine applications with peak power at 7000-8000 rpm depending on the application. Includes a burst panel flange in the lid |
| Description_FAB | Plenum top is machined for a standard “large” 6-1/8” x 3-1/8” burst panel. Burst panels, burst panel frame sets, and gaskets may be purchased from various manufacturers such as Allstar Performance or Specialty Fasteners |
| Description_FAB | With forced-induction and the short runner length the engine rpm at which peak power occurs is more likely to be coupled to the supercharger or turbocharger being used |
| Description_FAB | Intake design facilitates custom inlet duct and throttle body placement |
| Description_FAB | Low height to fit under a stock or mildly modified hood. |
| Description_FAB | Front entry plenum flange allows design & fabrication of special throttle body adapters or inlet ducts for custom installations |
| Description_FAB | High volume fuel rails and mounting hardware included with ¾”-16 o-ring ports (8 AN) |
| Description_FAB | Available in satin or black finish |