The Texas Speed OE Style LS Replacement Pushrods are a set of 16 stock-length pushrods for GM Gen III and Gen IV LS small block V8 engines. At 7.380" overall length they match the factory pushrod dimension, which makes them a direct replacement when rebuilding a stock engine or when a cam swap calls for fresh pushrods at factory length.
Texas Speed lists these pushrods for the 4.8L, 5.3L, 5.7L and 6.0L LS family, including the LS1, LS2, LS3, LS6, L99, LS4, LS9, LSA, LQ4, LQ9, L76 and L92. The set covers all 16 valves on one engine. Pushrod length should be confirmed on the engine if the cylinder heads, block deck, camshaft base circle or lifters have been changed from stock.
Specifications
- Overall length: 7.380"
- Quantity: Set of 16
- Type: OE style stock replacement pushrod
- Engine family: GM Gen III and Gen IV LS small block V8
- Engines listed by Texas Speed: 4.8L, 5.3L, 5.7L, 6.0L; LS1, LS2, LS3, LS6, L99, LS4, LS9, LSA, LQ4, LQ9, L76, L92
- Part number: TSP-7380-OE-16
FAQ
What engines do the Texas Speed 7.380" OE style pushrods fit?
Texas Speed lists these 7.380" pushrods for GM Gen III and Gen IV LS engines, including the 4.8L, 5.3L, 5.7L and 6.0L and the LS1, LS2, LS3, LS6, L99, LS4, LS9, LSA, LQ4, LQ9, L76 and L92.
How many pushrods are included in this set?
This is a set of 16 pushrods, enough for all eight cylinders of one LS V8 engine with two valves per cylinder.
Is 7.380" the stock LS pushrod length?
Yes. Texas Speed describes 7.380" as the stock length for GM LS Gen III and Gen IV engines, so these are a direct replacement for the factory pushrods in an otherwise stock valvetrain.
Can I use these pushrods after a camshaft swap?
They can be used when the required pushrod length is still 7.380". If the heads have been milled, the block decked, or the camshaft base circle or lifters changed, pushrod length should be checked on the engine before ordering since the correct length can differ from stock.
Are these Texas Speed pushrods vehicle specific?
No. They are an engine-family part for Gen III and Gen IV LS engines rather than a vehicle-specific part, so they fit any LS engine that uses the stock 7.380" pushrod length regardless of the chassis it is installed in.
