This SPC Performance zero-degree sleeve is used to set a baseline when adjusting camber and caster on 4x4 vehicles. Remove the tire, cotter pin and upper ball joint stud nut, break the taper free, and use a sleeve puller to remove the existing sleeve. Install the 23139 zero-degree sleeve to determine the change needed, then fit the correct degree sleeve. Rotating the sleeve 45 degrees splits the camber and caster adjustment. The clear zinc coating adds corrosion resistance.
- Zero-degree camber/caster reference sleeve
- Used to establish a baseline before selecting a degree sleeve
- Front adjustment range: camber/caster 0.00 degree
- Rotate 45 degrees to split camber and caster
- Clear zinc coating for corrosion resistance
- Recommended tool: 77880 sleeve puller
- One required per wheel
- Part number: 23139
FAQ
What is a zero-degree sleeve used for?
It establishes a baseline reading so the correct degree sleeve can be selected to change camber or caster.
Does it change alignment on its own?
No. The 23139 provides 0.00 degrees of change and is a setup reference before the correct degree sleeve is installed.
How many are needed?
One sleeve is required per wheel during setup.
What tool removes the existing sleeve?
An SPC 77880 sleeve puller is recommended to remove the existing sleeve.

