The Edelbrock 1308 is a VRS-4150 850 CFM four-barrel carburetor with a one-piece, 3.75 in tall aluminum body in a satin finish. It is a direct fit on 4150 and 4500 flange manifolds. It has annular boosters, mechanical secondaries, dual accelerator pump circuits, power valves on the primary and secondary sides, and four-circuit billet metering blocks with industry-standard screw-in bleeds and jets. Bore diameter is 1.750 in and main venturi diameter is 1.425 in.
Notes:
- Throttle arm includes common transmission kickdown take-off points.
- Built-in provisions for a GM three-wire TPS.
- Vacuum ports: two 3/8 in and two 3/16 in.
- Two auxiliary idle air screws, plus interchangeable idle jets and mixture screws on all four corners.
- Nitrophyl floats; jet extenders are fitted on the secondary side.
- Gasket included. Mounting hardware is not included.
Specifications:
- Brand: Edelbrock
- Part Number: 1308
- Part Type: Carburetor
- Series: VRS-4150
- CFM Rating: 850 cfm
- Barrel Quantity: 4 Barrel
- Flange Type: 4150 and 4500
- Material: Aluminum
- Finish: Satin
- Bore Diameter: 1.750
- Marine Approved: No
- Main Venturi Diameter: 1.425
- Body Height: 3.75
- Gasket Included: Yes
- Body Material: Aluminum
- Mounting Hardware Included: No
- Booster Type: Annular
- EGR Port: No
- Primary Power Valve: Yes
- Secondary Power Valve: Yes
- Metering Block: Billet- Four Circuit in
- Secondaries: Mechanical
- Intermediate Circuit: Yes
- Standard Vacuum: 2 - 3/8" dia. and 2- 3/16" dia
- Jet Extenders: Yes- Secondary Side
- Maximum Flow Rating: 850
- Accel Pump Well Size: 50
- Flange Shape: 4150 and 4500
- Ported Timed Vacuum: Yes (3/16)
- Manufacturer warranty: 12 months
Emissions Status
- For use on pre-pollution-controlled vehicles: 1965 and older U.S.-manufactured California-certified vehicles, 1967 and older U.S.-manufactured federally certified vehicles, and 1967 and older foreign-manufactured vehicles.
- For racing use only.
Race Use Only: This product is manufactured and sold for installation on vehicles used solely for competition. Once installed, the vehicle may not be used, registered, or licensed for use on a public road or highway. Installation on a street-driven vehicle may violate the Clean Air Act 203(a)(3), 42 U.S.C. 7522(a)(3).
FAQ
What manifolds does the Edelbrock 1308 fit?
It is a direct fit on 4150 and 4500 flange intake manifolds.
What boosters and secondaries does the 1308 use?
It uses annular boosters and mechanical secondaries, with power valves on both the primary and secondary sides.
What are the bore and venturi sizes of the 1308?
Bore diameter is 1.750 in and main venturi diameter is 1.425 in.
Does the 1308 work with a transmission kickdown and TPS?
Yes. The throttle arm includes common transmission kickdown take-off points, and the body has built-in provisions for a GM three-wire TPS.
Is the Edelbrock 1308 street legal?
It is not 50-state legal. Its emissions status is for pre-pollution-controlled vehicles and racing use only.
California Proposition 65: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.

