Diode Dynamics DD4025 is an LED resistor kit sold as a pair. Each resistor is rated at 50 watts and 6 ohm and has 6 inch leads. The resistors prevent the hyperblinking that occurs when LED bulbs replace incandescent turn signal bulbs. The kit includes the connectors needed for installation.
Notes:
- One resistor is usually enough to compensate for one bulb. A vehicle with four LED turn signals (front and rear) needs four resistors in total.
- To install, one side of the resistor connects to the positive turn signal wire and the other side connects to negative (ground). On a dual filament socket, a voltmeter can identify which of the two power wires to tap.
Included:
- Pair of resistors
- Connectors for installation
Specifications:
- Brand: Diode Dynamics
- Part Number: DD4025
- Type: Bulb Resistor
- Power Rating (W): 50
- Resistance (ohm): 6
- Lead Length: 6"
- Quantity: Pair
FAQ
What does the Diode Dynamics DD4025 resistor kit do?
DD4025 prevents hyperblinking after LED bulbs replace incandescent turn signal bulbs. The LED draws much less power, so the vehicle reads the bulb as burned out, and the added resistor makes up that load.
What are the specifications of the DD4025 resistors?
Each resistor is rated at 50 watts and 6 ohm and has 6 inch leads. The kit is sold as a pair.
How many DD4025 resistors are needed for a vehicle?
One resistor is usually enough to compensate for one bulb. If LED turn signals are installed at all four corners, four resistors are needed in total.
How is the DD4025 resistor installed?
One side of the resistor connects to the positive turn signal wire and the other side connects to negative (ground) using the included connectors. On a dual filament socket, a voltmeter on the two power wires shows which one carries voltage with the turn signal on.

