This is the mandrel itself: the machined piece that bolts to the Allstar ALL31030 crank pulley with three bolts while the factory vibration damper bolt stays in place. The mandrel bolt then threads into this mandrel instead of into the crankshaft, which is what isolates the pulley drive from crank harmonics and helps stop the bolt from working loose or snapping.
Sold as the mandrel alone (0.76 lbs), this is the part to order when replacing a worn or damaged mandrel without buying the full ALL31031 kit that bundles the spacers, pulley guides, and hardware. It works with 3, 4, and 5-stage dry sump pump drives and with belt-driven fuel pumps.
Spec Sheet: Allstar Spec Sheet
Compatibility
This part is built specifically for the Allstar ALL31030 crank pulley mandrel drive system. It is not a universal fastener or washer and is not intended for use outside that mandrel assembly. It supports 3, 4, and 5-stage dry sump pump drives, either alone or paired with a belt-driven fuel pump. The ALL31030 crank pulley is sold separately.
FAQ
Does this fit any crank pulley, or just the Allstar ALL31030?
It is built specifically for the Allstar ALL31030 crank pulley mandrel drive. It is not designed as a universal fit for other pulleys.
Why use a mandrel instead of bolting the pulley straight to the crank?
The mandrel isolates the pulley-driven accessories from the crankshaft, which cuts down on engine harmonics that can loosen or break the mandrel bolt over time.
What is the difference between this and the ALL31031 Crank Mandrel Kit?
This is the mandrel piece by itself (0.76 lbs). The ALL31031 kit weighs in at 2.2 lbs because it bundles the mandrel with the spacers, pulley guides, key, and bolts needed for a full install.
Is the ALL31030 crank pulley included?
No, the crank pulley is sold separately.

