This is the complete mandrel drive kit for Allstar's ALL31030 crank pulley, built to stop mandrel bolt breakage on 3, 4, and 5-stage dry sump pump drives. The mandrel bolts to the crank pulley with three bolts while the stock vibration damper bolt stays put, and the mandrel bolt threads into the mandrel rather than the crankshaft so engine harmonics do not work directly against it.
At 2.2 lbs, this kit carries considerably more than the mandrel alone: spacers, pulley guides, the mandrel key, mandrel bolts, and the end bolt and washer are all included, covering a full install rather than a single component swap. It works alone or alongside a belt-driven fuel pump. The ALL31030 crank pulley is sold separately.
Spec Sheet: Allstar Spec Sheet
Compatibility
This part is built specifically for the Allstar ALL31030 crank pulley mandrel drive system. It is not a universal fastener or washer and is not intended for use outside that mandrel assembly. It supports 3, 4, and 5-stage dry sump pump drives, either alone or paired with a belt-driven fuel pump. The ALL31030 crank pulley is sold separately.
FAQ
Does this fit any crank pulley, or just the Allstar ALL31030?
It is built specifically for the Allstar ALL31030 crank pulley mandrel drive. It is not designed as a universal fit for other pulleys.
Why use a mandrel instead of bolting the pulley straight to the crank?
The mandrel isolates the pulley-driven accessories from the crankshaft, which cuts down on engine harmonics that can loosen or break the mandrel bolt over time.
What is included in this kit that is not in the ALL31032 mandrel alone?
The full kit adds the mandrel spacers, pulley guides, mandrel key, mandrel bolts (3-pack), and the end bolt and washer on top of the mandrel itself, which is why it weighs 2.2 lbs versus 0.76 lbs for the mandrel by itself.
Is the ALL31030 crank pulley included?
No, the crank pulley is sold separately.

